TM-9-2320-328-13-P-2
HEMTT-BASED WATER TENDER (HEWATT)
TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 2 OF 3
MARCH 2009
TM-9-2320-328-13-P-2 - Page 67 of 1390
TM 9-2320-328-13&P-2
0116-7
DRAFT
0116
Change 1
.
Step 15.
Remove passenger side light bezel cover (WP 0335).
Disconnect passenger side body
wire harness clearance light connector at non-operating clearance marker.
Check for
22 to 28 VDC between wire 1606 (green) at passenger side body wire harness
clearance marker terminal and a know good ground.
.
If 22 to 28 VDC are present, go to Step 17.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
HWT3179
.
WARNING
.
ICON 3
.
Remove rings, wristwatches, neck chains, and any other jewelry before working
around vehicle.
Jewelry can catch on equipment and cause serious injury.
Jewelry
and tools may short across electrical circuits and cause damage to equipment, or
severe burns or electrical shock to personnel.
.
Step 16.
Turn Off Clearance Lamps (TM 9-2320-422-10).
Turn Service Drive Lights Off
(TM 9-2320-422-10).
Pull battery disconnect switch to off position (WP 0007).
Disconnect main wire harness passenger side body wire harness connector.
With a
test lead set, check for continuity across main wire harness wire 2740 (black) from main
wire harness passenger side body wire harness connector, terminals 8 and 10 to a
known good ground.
.
a.
If there is continuity at both terminals, repair wire 2740 in passenger
side body wire harness if repairable (TM 9-2320-325-14&P), or replace
passenger side body wire harness (WP 0298).
.
b.
If there is no continuity at either terminal, repair wire 2740 in main wire
harness if repairable (TM 9-2320-325-14&P), or replace main wire
harness (WP 0292).
.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Back to Top
