TM-9-2320-328-13-P-2
HEMTT-BASED WATER TENDER (HEWATT)
TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 2 OF 3
MARCH 2009
TM-9-2320-328-13-P-2 - Page 76 of 1390
TM 9-2320-328-13&P-2
0116-16
DRAFT
0116
Change 1
.
HWT0628
.
WARNING
.
ICON 3
.
Remove rings, wristwatches, neck chains, and any other jewelry before working
around vehicle.
Jewelry can catch on equipment and cause serious injury.
Jewelry
and tools may short across electrical circuits and cause damage to equipment, or
severe burns or electrical shock to personnel.
.
Step 31.
Pull battery disconnect switch to off position (WP 0007).
Remove six screws holding
sunscreen and place instrument panel in service position (TM 9-2320-325-14&P).
Remove flasher relay (TM 9-2320-325-14&P).
Install a test lead set between cab wire
harness flasher relay connector terminals wire 1080 and turn signal ‘Flasher’ yellow
wire.
Remove left side clearance/turn light (WP 0228).
Push battery disconnect switch
to on position (WP 0007).
Turn Service Drive Lights On (TM 9-2320-422-10).
Turn left
turn signal on (TM 9-2320-325-14&P).
With a test lead set, check for 22 to 28 VDC
between main wire harness wire 1411 (yellow) at left side clearance/turn light
connector, terminal 3 and a known good ground.
.
If 22 to 28 VDC are present, replace left side clearance/turn light (WP 0228).
.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Back to Top
