TM-9-2320-328-13-P-2
HEMTT-BASED WATER TENDER (HEWATT)
TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 2 OF 3
MARCH 2009
TM-9-2320-328-13-P-2 - Page 82 of 1390
TM 9-2320-328-13&P-2
0116-22
DRAFT
0116
Change 1
.
HWT0625
.
Step 38.
Disconnect main wire harness from non-operating side clearance/turn light
connector (WP 0228).
With a test lead set, check for 22 to 28 VDC between wire H012
(white) at main wire harness side clearance/turn light connector, terminal 2 and a known
good ground.
.
If 22 to 28 VDC are not present, repair wire H012 in main wire harness
(TM 9-2320-325-14&P), or replace main wire harness (WP 0292).
.
Step 39.
Turn Service Drive Lights Off (TM 9-2320-422-10).
Pull battery disconnect switch to off
position (WP 0007).
With a test lead set, check for continuity across main wire harness
wire 1640 (black) from main wire harness side clearance/turn light connector, terminal 1
and a known good ground.
.
a.
If there is continuity, replace non-operating side clearance/turn
light (WP 0228).
.
b.
If there is no continuity, repair wire 1640 in main wire harness if
repairable (TM 9-2320-325-14&P), or replace main wire harness
(WP 0292).
.
Step 40.
Remove one non-operating side clearance/turn light (WP 0228).
With a test lead set,
check for 22 to 28 VDC between wire H012 (white) at main wire harness side
clearance/turn light connector, terminal 2 and a known good ground.
.
If 22 to 28 VDC are present, repair wire 1640 if repairable
(TM 9-2320-325-14&P), or replace main wire harness (WP 0292).
.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Back to Top
