TM-9-2320-328-13-P-2
HEMTT-BASED WATER TENDER (HEWATT)
TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 2 OF 3
MARCH 2009
TM-9-2320-328-13-P-2 - Page 89 of 1390
TM 9-2320-328-13&P-2
0117-5
DRAFT
0117
Change 1
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
HWT3191
.
WARNING
.
ICON 3
.
Remove rings, wristwatches, neck chains, and any other jewelry before working
around vehicle.
Jewelry can catch on equipment and cause serious injury.
Jewelry
and tools may short across electrical circuits and cause damage to equipment, or
severe burns or electrical shock to personnel.
.
Step 4.
Install circuit breaker FS 9 (WP 0242).
Disconnect main wire harness driver side body
wire harness connector.
Push battery disconnect switch to on position (WP 0007).
Turn Service Drive Lights On (TM 9-2320-422-10).
With a test lead set, check for 22 to
28 VDC between wire 1188 (red) at main wire harness driver side body wire harness
connector, terminal J and a known good ground.
.
If 22 to 28 VDC are not present, go to Step 7.
.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Back to Top
