TM-9-2320-328-13-P-2

HEMTT-BASED WATER TENDER (HEWATT)

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 2 OF 3

MARCH 2009

TM-9-2320-328-13-P-2 - Page 98 of 1390

TM 9-2320-328-13&P-2

0117-14

DRAFT

0117

Change 1

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

.

HWT3318

.

WARNING

.

ICON 3

.

Remove rings, wristwatches, neck chains, and any other jewelry before working

around vehicle.

Jewelry can catch on equipment and cause serious injury.

Jewelry

and tools may short across electrical circuits and cause damage to equipment, or

severe burns or electrical shock to personnel.

.

Step 15.

Disconnect driver side body 4-pin wire harness connector.

Pull battery disconnect

switch to on position (WP 0007).

Turn Service Drive Light On (TM 9-2320-422-10).

With a test lead set, check for 22 to 28 VDC between wire 1188 at driver side body wire

harness 4-pin connector, terminal 3 to a known good ground.

.

a.

If 22 to 28 VDC are present, repair wire 1188 in upper driver side body

wire harness if repairable (TM 9-2320-325-14&P), or replace driver

side body wire harness (WP 0286).

.

b.

If 22 to 28 VDC are not present, repair wire 1188 in lower driver side

wire harness if repairable (TM 9-2320-325-14&P), or replace driver

side body wire harness (WP 0286).

.

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION