TM-9-2320-328-13-P-2
HEMTT-BASED WATER TENDER (HEWATT)
TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 2 OF 3
MARCH 2009
TM-9-2320-328-13-P-2 - Page 95 of 1390
TM 9-2320-328-13&P-2
0117-11
DRAFT
0117
Change 1
.
HWT3006
.
NOTE
If wire 1474 cannot be identified at door switch, measure continuity across both black wire
terminals to ground.
Continuity should be measured between all terminals, when switch is
closed (door switch is not pressed).
.
Step 11.
Turn Service Drive Light Off (TM 9-2320-422-10).
Pull battery disconnect switch to off
position (WP 0007).
Remove door switch from driver side stowage hatch
T3 (WP 0246).
Do not disconnect wires.
With a test lead set, check for continuity
between door switch terminal wire 1474 (black) and a known good ground when switch
is closed (door switch is not pressed).
.
If there is continuity, go to Step 14.
.
Step 12.
Check for continuity across door switch between terminal wire1474 and terminal wire
2460.
.
If there is no continuity, replace door switch (WP 0246).
.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Back to Top
