TM-9-2320-328-13-P-2
HEMTT-BASED WATER TENDER (HEWATT)
TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 2 OF 3
MARCH 2009
TM-9-2320-328-13-P-2 - Page 93 of 1390
TM 9-2320-328-13&P-2
0117-9
DRAFT
0117
Change 1
.
HWT2884
.
WARNING
.
ICON 3
.
Remove rings, wristwatches, neck chains, and any other jewelry before working
around vehicle.
Jewelry can catch on equipment and cause serious injury.
Jewelry
and tools may short across electrical circuits and cause damage to equipment, or
severe burns or electrical shock to personnel.
.
Step 9.
Turn Service Drive Lights Off (TM 9-2320-422-10).
Pull battery disconnect switch to off
position (WP 0007).
Disconnect non-operating driver side stowage hatch T3 striplight.
Turn Service Drive Light ON (TM 9-2320-279-10). Push battery disconnect switch to on
position (WP 0007).
With a test lead set, check for 22 to 28 VDC between wire 1188 at
driver side body wire harness driver side hatch striplight connector, terminal A to a
known good ground.
.
If 22 to 28 VDC are not present, repair wire 1188 in upper driver side body
wire harness if repairable (TM 9-2320-325-14&P), or replace driver side
body wire harness (WP 0286).
.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Back to Top
