TM-9-2320-361-10

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

OPERATOR'S MANUAL

DECEMBER 1988

TM-9-2320-361-10 - Page 211 of 392

TM 9-2320-361-10

2-31. OPERATION OF PIPELINE CONSTRUCTION

MAINTENANCE TRUCKS (Contd)

(15)

If safety brake does not hold load, turn brake adjustment screw (4)

clockwise (from under truck) to tighten brake.

(16)

To lower load or unwind winch under power:

(a)

Depress clutch pedal (3).

(b)

Place transmission gearshift lever (1) in “N” (neutral) position.

(c)

Release clutch pedal (3) slowly.

(17)

At end of winch operations:

(a)

Depress clutch pedal (3).

(b)

Place transmission gearshift lever (1) in “N” (neutral) position.

(c)

Disengage transfer power takeoff lever (2) and secure.

(d)

Shut off engine. Refer to para. 2-17.

(18)

Pull out winch lock knob (6) and rotate 90° until it engages poppet nut (7).

(19)

Turn winch drum (5) until poppet engages winch drum flange.

(20)

Lift jack legs (9) and (11) to level position, push into stowage

compartment about 1 foot, and remove safety pins (10) and tee locking pin (8).

(21)

Slide leg (9) into leg (11).

(22)

Install tee locking pin (8) in hole, but do not let pin extend out of other

side of leg (11).

(23)

Slide legs (9) and (11) into compartment, turn tee locking pin (8) handle

to up and down position, and push all the way in.

(24)

Install safety pin (10) in tee locking pin (8).

2-150