TM-9-2320-361-20
2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; UNIT MAINTENANCE
OCTOBER 1991
TM-9-2320-361-20 - Page 693 of 1207
TM 9-2320-361-20
10-8.
BRUSH GUARD, STONE SHIELD, AND HEADLIGHT GUARD REPLACEMENT
This task covers:
a. Stone Shield Removal
d. Headlight Guard Installation
b. Brush Guard Removal
e. Brush Guard Installation
c. Headlight Guard Removal
f. Stone Shield Installation
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
All
TM 9-2320-361-10
MATERIALS/PARTS
TM 9-2320-361-20P
Twenty-three locknuts
EQUIPMENT CONDITION
Parking brake set (TM 9-2320-361-10).
a. Stone Shield Removal
NOTE
Radiator stone shield consists of an upper and lower stone shield.
On vehicles with a front winch, a lower stone shield is not used.
Some vehicles may have washers between brush guard and brush
guard bracket.
1. Remove four locknuts (19), screws (10), two washers (15), and lower stone shield (9) from brush
guard (4) and upper stone shield (7). Discard locknuts (19).
2. Remove three locknuts (5), screws (8), brackets (6), and upper stone shield (7) from brush guard (4).
Discard locknuts (5).
b. Brush Guard Removal
1. Loosen two locknuts (16) and screws (18) from brush guard (4) and frame rail brackets (17). Discard
locknuts (16).
2. Remove four locknuts (1) and (22), four washers (21) and (14), screws (20) and (13), and brush
guard (4) from angle brackets (3). Discard locknuts (1) and (22).
NOTE
On vehicles without front winch, there is an additional brush
guard bracket.
If vehicle is equipped with stone shield, proceed to step 4.
3. Remove two locknuts (19), screws (10), washers (15), and upper brush guard bracket (12) from brush
guard (4).
4. Remove two locknuts (19), screws (10), washers (15), and lower brush guard bracket (11) from brush
guard (4). Discard locknuts (19).
c. Headlight Guard Removal
NOTE
This procedure can also be done with brush guard installed on
vehicle.
1. Remove four locknuts (1), screws (20), and washers (21) from brush guard (4). Discard locknuts (1).
2. If brush guard (4) was not removed from vehicle, remove two locknuts (22), washers (14),
screws (13), and headlight guard (2) from brush guard (4). Discard locknuts (22).
10-10
Back to Top
