TM-9-2320-361-20
2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; UNIT MAINTENANCE
OCTOBER 1991
TM-9-2320-361-20 - Page 703 of 1207
TM 9-2320-361-20
11-5. CAB DOOR GIASS AND WEATHERSEAL REPLACEMENT
This task covers:
a. Removal
c. Cab Door Glass Adjustment
b. Installation
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
All
TM 9-2320-361-10
MATERIALS/PARTS
TM 9-2320-361-20P
Two fasteners
EQUIPMENT CONDITION
Four lockwashers
Parking brake set (TM 9-2320-361-10).
Cab door inspection hole cover removed
(para. 11-2).
1. Lower cab door glass (8) so regulator channels (2) are accessible through cab door (4) inspection
hole.
NOTE
Mark position of regulator stop brackets for installation.
2. Remove four screws (7), lockwashers (6), and two window regulator stop brackets (5) from regulator
channels (2), Discard lockwashers (6).
3. Remove two fasteners (1) from window regulator arm studs (3). Discard two fasteners (1).
4. Pull two regulator arm studs (3) out of two regulator channels (2) and slide cab door glass (8) out of
cab door (4).
5. Remove weatherseal (10) from cab door (4).
6. Remove five clips (9) from weatherseal (10).
1. Install five clips (9) to weatherseal (10) and aline clips (9) with panel slots (11).
2. Install weatherseal (10) and clips (9) on cab door (4) so clips (9) snap into corresponding panel
slots (11).
3. Slide cab door glass (8) into cab door (4) and install two window regulator arm studs (3) through two
regulator channels (2).
4. Install two new fasteners (1) on window regulator arm studs (3).
5. Install two window regulator stop brackets (5) on regulator channels (2) with four new lock-
washers (6) and screws (7). Do not tighten.
c. Cab Door Glass Adjustment
1. Raise cab door glass (8) to full up position.
11-6
Back to Top
