TM-9-2320-361-34

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

MAY 1992

TM-9-2320-361-34 - Page 118 of 764

TM 9-2320-361-34

3-18. ENGINE REPLACEMENT (Contd)

CAUTION

Before removing transmission, ensure transmission is properly

supported. Failure to do so may result in damage to equipment.

46. Position transmission jack or wooden supports under transmission (13).

47. Remove twelve screw-assembled lockwashers (12) from transmission (13) and flywheel housing (11).

Discard screw-assembled lockwashers (12).

48. Remove transmission (13) and gasket (14) from flywheel housing (11). Discard gasket (14).

NOTE

If

clutch replacement is required, perform step 49.

49. Remove pressure plate and clutch (para. 4-1).

I

b. Installation

I

1.

2.

3.

4.

Remove all plugs or caps prior to installation. Failure to do so may

result in damage to equipment.

NOTE

Perform step 1 if clutch and pressure plate were removed.

Install pressure plate and clutch (para. 4-1).

Position transmission (13) to flywheel housing (11) with transmission jack.

Install new gasket (14) and transmission (13) on flywheel housing (11) with twelve new screw-

assembled lockwashers (12). Tighten screw-assembled lockwashers ( 12) 23-26 lb-ft (31-35 N.m).

Remove transmission jack from transmission (13).

3-67