TM-9-2320-361-34

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

MAY 1992

TM-9-2320-361-34 - Page 120 of 764

TM 9-2320-361-34

I

3-18. ENGINE REPLACEMENT (Contd)

13.

14.

15.

16.

17.

18.

19.

20,

Keep hands clear of supported engine during placement of engine

mounts. Failure to do so may result in injury to personnel.

Position two mounting pads (20) and (31) on frame (23) and crossmember (30).

Lower engine (1) until it rests on frame (23) and crossmember (30). Ensure mounting holes are alined.

Install two washers (32), screws (33), lower mounting pads (29), washers (28), and new lock-

nuts (27) on support plate (10) and crossmember (30). Tighten locknuts (30) 65-70 lb-ft (88-95 N.m).

Install two washers (18), screws

(17),

lower mounting pads (24), washers (25), and new locknuts (26)

on frame (23). Finger tighten locknuts (26).

Tighten locknuts (26) 65-70 lb-ft (88-95 N.m).

Remove lifting device and sling from chain and lifting eye (11).

Remove nut

(15),

screw (16), washers (14) and (13), and chain from lifting eye (16).

NOTE

Perform step 20 if

vehicle is equipped with transmission power takeoff.

Position clevis (22) on power takeoff arm (19) and push pin (21) in clevis (22) until head of pin (21)

seats against clevis (22).

)

LIFTING DEVICE

SLING \

3-69