TM-9-2320-361-34

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

MAY 1992

TM-9-2320-361-34 - Page 119 of 764

TM 9-2320-361-34

3-18. ENGINE REPLACEMENT

(Contd)

5. Install two rear engine supports (2) on engine (1) with eight new locknuts (3). Tighten

locknuts (3) 45-55 lb-ft (61-75 N.m).

6. Install two front engine supports (9) on engine (1) with four washers (4), two screws (5), and

screws (6). Tighten screws (5) and (6) 200-250 lb-ft (271-339 N.m).

7. Install support plate (10) on two front engine supports (9) with six washers (8) and screws (7).

Tighten screws (7) 24-27 lb-ft (33-37 N.m).

8.

9.

10.

Install chain on lifting eye (16) with washers (14) and (13), screw (16), and nut (15).

Connect lifting device to sling.

Connect sling to lifiing eye (11) and chain.

11.

12.

●

Lifiing device must have a weight capacity greater than the

weight of the engine and transmission to prevent damage to

equipment and injury to personnel.

●

All personnel must stand clear during lifting operations. A

swinging or shifling load may cause injury to personnel.

●

Use prybar to free engine during lifting operations. Failure to do

so may cause injury to personnel.

o

Do not detach chain from engine until all engine weight is equally

distributed and engine is stable. A improperly supported engine

may cause injury to personnel.

Raise engine (1) from supports.

NOTE

●

Two assistants will help with step 12.

●

Engine angle must be adjusted constantly during engine

installation.

Lower engine (1) into engine compartment. Do not lower completely.

3-68