TM-9-2320-361-34

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

MAY 1992

TM-9-2320-361-34 - Page 495 of 764

TM 9-2320-361-34

15-43. MAIN DRIVE IDLER GEAR MAINTENANCE

(Contd)

d. Assembly

1. Press two new oil seals (15) in retainers (12).

2. Install shaft (25) with two bearings (24) and main drive gear (27) in housing (5).

3. Install new O-ring (28) and collar (14) on shaft (25). Tighten setscrew (13).

4. Apply sealant to gasket surfaces and install two new gaskets (16) and retainers (12) on housing (5)

with eight new lockwashers (10) and screws (11).

5. Apply

sealant

to gasket surfaces and install new gasket (31), new woodruff key (26), and flange (18)

on shaft (25) with washer (23), nut (22), and new cotter pin (21).

6. Install two new O-rings (8) on shaft (9).

NOTE

Ensure teeth of idler gear mesh with those of main drive gear

during installation.

7. Install idler gear (4) in housing (5) with shaft (9), nut (30), and new cotter pin (29).

e. Installation

NOT E

Assistant will help with step 1.

1. Apply sealant to gasket surfaces and install new gasket (3) and housing (5) on clutch case (1) with

eight screws (2), new lockwashers (6), and nuts (7).

2. Install shaft flange (19) on flange (18) with four screws (20) and new locknuts (17).

15-184