TM-9-2320-361-34

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

MAY 1992

TM-9-2320-361-34 - Page 499 of 764

15-188

TM 9-2320-361-34

15-44.

BRAKE, FEED, AND DRIVE CLUTCH MAINTENANCE

(Contd)

7.

8.

9.

10.

11.

12.

13.

14.

Install chains on case (7), attach lifting device to chains, and apply tension to chains.

Remove four nuts (1), six screws (3), and lockwashers (2) from case (7) and clutch and brake (4).

Discard lockwashers (2).

●

●

WARNING

Be prepared to support clutch and brake otherwise it may fall and

cause injury to personnel, and/or damage to equipment.

All personnel must stand

clear during lifting operations.

A snapped

chain,

shifting

or swinging

load may cause injury to

personnel.

NOTE

Assistant will help with lifting operations.

Slide case (7) and gasket (6) off clutch and brake (4). Discard gasket (6).

Remove lifting device and chains from case (7).

Remove bearing (30), drive sleeve (10) with clutch assembly (5), and woodruff

key (13) from drive

shaft (12). Discard woodruff

key (13).

NOTE

If adjusting depth of feed pinion, proceed to step 20.

Remove safety wire (21), loosen setscrew (22), and remove adjusting nut (29) and bearing (28) from

drive sleeve (10). Discard safety wire (21).

Remove brake hub (27) with thirteen clutch plates (25) and (26) from drive sleeve (10).

NOTE

Note

number and sequence of clutch plates before removing from

brake hub.

Remove thirteen clutch plates (25) and (26) from brake hub (27). Tie clutch plates (25) and (26)

together in sequence.