TM-9-2320-361-34
2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
MAY 1992
TM-9-2320-361-34 - Page 505 of 764
TM 9-2320-361-34
I
15-44. BRAKE, FEED, AND DRIVE CLUTCH MAINTENANCE (Contd)
c. Assembly
●
●
●
●
NOTE
If adjusting depth of drive pinion, proceed to steps 40 and 44
through 47.
If adjusting depth of feed pinion, perform steps 42 through 47.
Coat all brake and clutch plates with oil before installation.
Pack all bearings with GAA grease before assembly.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
Install retainer (4) and sleeve (1) in main support tube (5).
NOTE
. Apply sealing compound on gasket mating surfaces before
installation.
●
Install
all
shims to previous recorded distances.
Place new gasket (9) and brake shell (10) on main support tube (5).
Install new shims (3) and bearing (2) on feed shaft (6) and insert feed shaft (6) through sleeve (1)
and into main support tube (5).
Install thirteen clutch plates (12) and (13) on brake hub (11) in number and sequence noted.
Install new woodruff key (7) and brake hub (11) on feed shaft (6).
Install sleeve bearing (17) on brake hub (11).
Install brake pressure plate (14) with adjusting nut (15), throw ring (16), and bearing (18) with
clutch pressure plate (19) on sleeve bearing (17).
Install clutch plates (20), (21), and (22) on clutch hub (23) in number and sequence noted.
Install clutch hub (23) on feed shaft (6).
Install bearing (24) and adjusting nut (25) on feed shaft (6).
Tighten adjusting nut (15) to eliminate end play of bearing (24) and hubs (11) and (23). Tighten
setscrew (27) and install new safety wire (26).
Rotate adjusting nut (15) to apply pressure to brake pressure plate (14) until adjusting nut (15)
becomes tight. Then back adjusting nut (15) off 3/8 turn (4 to 5 notches) until lock groove is engaged.
Install main drive gear (28) on bearing (24).
Install drive shaft (8) in feed shaft (6).
15-194
Back to Top
