TM-9-2320-361-34

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

MAY 1992

TM-9-2320-361-34 - Page 504 of 764

TM 9-2320-361-34

15-44.

BRAKE, FEED, AND DRIVE CLUTCH MAINTENANCE (Contd)

4. Inspect two brake shells (4), four hubs (11), and main drive gear (14) for notching of splines. Replace

if damaged.

5. Inspect all clutch plates (6), (7), and (13) for scoring and scorching. Replace all clutch plates if

damaged.

6. Inspect lining of clutch plates (13) for damage and wear. Plate thickness should be 0.138-0.106 in.

(3.50-2.69 mm). Place clutch plate (13) on clutch pressure plate

(8) and check for coning by using

feeler gage to measure gap

at inside diameter. Gap should not exceed 0.15 in. (0.38 mm). Replace if

worn or damaged.

7., Inspect clutch cap (5), clutch case cap (2), and clutch case cap cover (1) for chips, cracks, and small

holes. Repair cracks or small holes by welding. Refer to TM 9-237. Replace if damaged.

15-193