TM-9-2320-361-34
2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
MAY 1992
TM-9-2320-361-34 - Page 511 of 764
TM 9-2320-361-34
15-44.
BRAKE, FEED, AND DRIVE CLUTCH MAINTENANCE
(Contd)
40.
41.
42.
43.
44.
45.
46.
47.
NOTE
●
If
alinement
is
correct,
proceed
to
step
44.
●
If
depth of
drive
pinion
is
incorrect,
perform
steps
40,
41,
and
44
through 47.
●
If
depth of feed
pinion
is
incorrect,
perform steps
42
through 47.
Remove four screws (20), lockwashers
(21),
clutch case cap cover (17), and gasket (18) from clutch
case (1). Discard lockwashers (21) and gasket (18).
To increase the depth of drive pinion (26), add shims (19). To decrease the depth of drive pinion (26),
remove shims (19).
NOTE
●
Apply sealing compound to gasket mating surfaces before
installation.
. Intermediate gear and case must be removed from main support
tube in order to adjust depth of feed pinion. Perform removal
steps of para. 15-42, then disassemble brake, feed, and drive
clutch and add or remove shims as necessary.
To increase depth of feed pinion (24), add shims (22) and remove shims (23) in equal thicknesses. To
decrease depth, remove shims (22) and add shims (23) in equal thicknesses.
Install intermediate gear and case (27) on main support tube (25). Refer to installation steps of
para. 15-42.
Install four new O-rings (6), sleeves (4), and rings (3) on two cams (5) and two cams (13).
Install two cams (5), new gaskets (2), and cam housings (7) on clutch case (1) with eight new
lockwashers (8) and screws (9).
Install two cams (13), new gaskets (14), and cam housings (12) on clutch case (1) with eight new
lockwashers (11) and screws (10).
Install nipple (16) and dipstick (15) on clutch case (1).
15-200
Back to Top
