TM-9-2320-365-34-2

M1078 SERIES, 2 1/2-TON, 4 X 4, LIGHT MEDIUM TACTICAL VEHICLES (LMTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME NO. 2 OF 2

AUGUST 2005

CHANGE 2

TM-9-2320-365-34-2 - Page 477 of 1414

TM 9-2320-365-34-2

Change 2

9-8.1

(12.1) Remove drive shaft (14.1) from crossmember

(14.2).

(13) Position universal joint (15) on drive yoke (16)

with two bearing cups (17) and four screws (18).

(13.1) Tighten four screws (18) to 26-35 lb-ft (35-47 N•m).

WARNING

CAUTION

NOTE

Step (12.1) requires the aid of an assistant.

Do not use steel hammers to seat bearing

cups in drive yokes.

Failure to comply

may result in injury to personnel or

damage to equipment.

Check bearing cups to ensure all needle

bearings are in place prior to installation.

Replace bearing cups if needle bearings are

missing or out of place.

Failure to comply

may result in damage to equipment.

NOTE

•

Wipe end of yoke bearing bores prior to

installation.

•

There are two types of bearing cups, those

with tabs and those without. Perform the

following step on bearing cups not

equipped with tabs.

NOTE

Perform the following step on kits equipped

with screws P/N C5H5-24-39.