TM-9-2320-366-20-1
M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5
FEBRUARY 2006
CHANGE 3
TM-9-2320-366-20-1 - Page 1023 of 1824
TM 9-2320-366-20-1
Change 1
2-604.91
M1089 Splice
M1085/M1086
/M1096 Splice
Connector
Marker Light
P95
RH Side
RH Rear
Right Rear
Middle Rear
Left Rear
LH Rear
LH Side
LH Intermediate
P94
P85
P86
P54
P56
P58
P89
P88
RH Intermediate
Table 2-12.4.
M1085/M1086/M1089/M1096 Intermediate,
Side, and Rear Marker Light Connectors and Splices
Splice E64
Splice E16
Splice E16
Splice E15
Splice E15
Splice E15
Splice E17
Splice E17
Splice E64
Splice E51
Splice E51
Splice E49
Splice E49
Splice E50
Splice E50
Splice E50
Splice E52
Splice E52
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle.
Jewelry can catch on equipment and
cause injury or short across electrical circuits, or
cause severe burns or electrical shock.
CAUTION
Use care when testing electrical connectors not
to bend connector pins or damage connector
sockets with multimeter probes.
Failure to
comply may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability.
Check that
connector pins are not pushed back and
are capable of making good contact.
VOLTAGE TEST
(1) Disconnect marker light connector from
connector (refer to Table 2-12.4.
M1085/
M1086/M1089/M1096 Intermediate, Side,
and Rear Marker Light Connectors and
Splices).
(2) Set multimeter to volts DC.
(3) Connect positive (+) probe of multimeter
to connector (refer to Table 2-12.4.
M1085/M1086/M1089/M1096
Intermediate, Side, and Rear Marker Light
Connectors and Splices).
(4) Connect negative (-) probe of multimeter to
ground.
(5) Position main light switch to SER DRIVE
(TM 9-2320-366-10-1) and note reading
on multimeter.
(6) Position main light switch to OFF
(TM 9-2320-366-10-1).
(7) If 12 VDC is not present, repair wire 489
(refer to Table 2-12.4.
M1085/M1086/
M1089/M1096 Intermediate, Side, and
Rear Marker Light Connectors and Splices)
(para 2-45) or replace M1086/M1089 rear
lights cable assembly (para 7-104) or
M1085/M1096 rear lights cable assembly
(para 7-84).
Back to Top
