TM-9-2320-366-20-1
M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5
FEBRUARY 2006
CHANGE 3
TM-9-2320-366-20-1 - Page 1025 of 1824
TM 9-2320-366-20-1
Change 1
2-604.93
CONTINUITY TEST
Marker Light
LH Intermediate
LH Side
LH Rear
Left Rear
Middle Rear
Right Rear
RH Rear
RH Side
RH Intermediate
TL19
TL20
TL32
TL31
TL30
TL16
TL15
TL88
Terminal Lug
M1089
TL89
M1085/M1086/M1096
Wire 3089 from Terminal Lug TL88
to Terminal Lug TL90
Wire 3094 from Terminal Lug TL15
to Terminal Lug TL16
Replace Marker Light (para 7-38)
Replace Marker Light (para 7-38)
Replace Marker Light (para 7-38)
Replace Marker Light (para 7-38)
Replace Marker Light (para 7-38)
Replace Marker Light (para 7-38)
Replace Marker Light (para 7-38)
Replace Marker Light (para 7-38)
Wire 3094 from Terminal Lug TL32
to Terminal Lug TL31
Wire 3095 from Terminal Lug TL19
to Terminal Lug TL20
Wire 3090 from Terminal Lug TL89
to Terminal Lug TL90
Wire 3090 from Terminal Lug TL89
to Terminal Lug TL90
Wire 3095 from Terminal Lug TL19
to Terminal Lug TL20
Wire 3094 from Terminal Lug TL30
to Terminal Lug TL31
Wire 3094 from Terminal Lug TL15
to Terminal Lug TL16
Wire 3089 from Terminal Lug TL88
to Terminal Lug TL90
Table 2-12.5.
M1085/M1086/M1089/ M1096 Intermediate, Side, and Rear Marker Light Terminal Lugs
(8) Connect marker light connector to
connector (refer to Table 2-12.5.
M1085/
M1086/ M1089/M1096 Intermediate,
Side, and Rear Marker Light Terminal Lugs).
(1) Remove nut, lockwasher, terminal lug, and
lockwasher from marker light screw.
Discard
lockwashers.
(2) Set multimeter to ohms.
(3) Connect positive (+) probe of multimeter
to terminal lug (refer to Table 2-12.5.
M1085/M1086/ M1089/M1096
Intermediate, Side, and Rear Marker Light
Terminal Lugs).
(4) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(5) If continuity is not present, repair wire (Refer
to Table 2-12.5.
M1085/M1086/ M1089/
M1096 Intermediate, Side, and Rear
Marker Light Terminal Lugs) (para 2-45) or
replace M1086/M1089 rear lights cable
assembly (para 7-104) or M1085/M1096
rear lights cable assembly (para 7-84).
(6) If continuity is present, replace marker
light (para 7-38).
(7) Install lockwasher, terminal lug,
lockwasher, and nut on marker light screw.
Back to Top
