TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-1 - Page 1029 of 1824

Change 1

2-604.97

TM 9-2320-366-20-1

WARNING

VOLTAGE TEST

CAUTION

Table 2-12.6.

M1085/M1086/M1089/M1096

Intermediate Marker Light Splices

Model

M1085/M1086/M1096

M1089

E64

E49

Splice

(1)

Disconnect LH intermediate marker light

connector from connector P94.

(2)

Set multimeter to volts DC.

(3)

Connect positive (+) probe of multimeter

to connector P94.

(4)

Connect negative (-) probe of multimeter to

ground.

(5)

Position main light switch to SER DRIVE

(TM 9-2320-366-10-1) and note reading

on multimeter.

(6)

Position main light switch to OFF

(TM 9-2320-366-10-1).

(7)

If 12 VDC is not present, repair wire 489

from connector P94 to splice (refer to Table

2-12.6.

M1085/M1086/M1089/M1096

Intermediate Marker Light Splices) (para

2-45) and go to step 5 of this fault if

required or replace M1086/M1089 rear

lights cable assembly (para 7-104) or

M1085/M1086 rear lights cable assembly

(para 7-84) and go to step 1 of this fault.

Use care when testing electrical connectors not

to bend connector pins or damage connector

sockets with multimeter probes.

Failure to

comply may result in damage to equipment.

Remove rings, bracelets, watches, necklaces,

and any other jewelry before working around

vehicle.

Jewelry can catch on equipment and

cause injury or short across electrical circuits, or

cause severe burns or electrical shock.

Inspect connector pins/sockets for damage,

corrosion, and serviceability.

Check that

connector pins are not pushed back and

are capable of making good contact.

NOTE