26.
Install new O-rings (1) and (6) and fuel line (3) on adapter (8) of governor (7) and tee fitting (5), and
tighten nuts (2) and (4).
27.
Install bracket (12), with accelerator cable (10) and throttle control cable (11) attached, on
governor (7) with two washers (13) and screws (14).
28.
Install bracket (9), with accelerator cable (10) and throttle control cable (11) attached, on throttle
lever (17) with washer (16) and nut (15).
29.
Install new gasket (18) and crankcase breather base (19) on engine (29) with two washers (20),
screws (21), washers (28), and screws (27).
30.
Install
breather tube (25) on engine (29) with spacer (26), clamp (22), washer (23), and screw (24).
31.
Install ground (GND) strap (33) to stud (30) on firewall (31) with new lockwasher (32) and new
locknut (34).
32.
Install new O-ring (38) and fuel line (39) on elbow (36) at rear of cylinder head (37), and tighten nut (35).
7
~
8
1
2
3
4
6
5
7
~
15
16
17
9
10
11
12
13
14
TM 9-2320-386-24-1-2
0302 00
CYLINDER HEAD (IN-VEHICLE) MAINTENANCE (Contd)
0302 00-24