TM-9-2320-387-24-1

TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE, VOLUME 1

DECEMBER 1997

CHANGE 1

TM-9-2320-387-24-1 - Page 541 of 1205

TM

9-2320-387-24-l

1 2-46.

STEACE-R TEST PROCEDURES

(Cont’d)

I

PRESSURE (PSI) 0 TO 1,000 TEST #50

‘Description:

Pre-Test Procedures:

This procedure

measures pressure in the 0

to 1,000 PSIG range. Test requires the use

of the TK adapters

and transducers.

Run confidence

test.

Typical

Applications:

Oil pressure

Control

Functions:

01,02,03.04,

06

Test Procedure:

Possible

Error Messages:

1. Attach connector

Pi of cable W4 to J2 TK or

J3 TK.

2. Install blue-striped

pressure transducer

where

pressure is to be measured.

Attach connector

P2 of cable W4 to transducer.

3. Set TEST SELECT switch to 50. Press and

hold TEST button until CAL appears on

display.

4. Release TEST button and watt for offset value

to appear on display. If offset is within -150 to

150, proceed.

If not, go to DCA

Troubleshooting

Procedure.

5. Energize system.

6. Press and release TEST button.

7. Observe displayed value.

E005 Offset not performed.

E002 Transducer

not connected.

2-495