TM-9-2320-387-24-1
TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113
TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE, VOLUME 1
DECEMBER 1997
CHANGE 1
TM-9-2320-387-24-1 - Page 559 of 1205
TM 9-2320-387-24-l
[
2-46.
STE/ICE-R TEST PROCEDURES
(Cont’d)
I
(d) Error Readout. EOOl is a typical error readout. There are 15 different readouts. All error readouts
start with E. An error readout is a warning that you forgot to connect the transducer, selected a wrong test
number, failed to start the engine, etc. All of the error messages mean you must correct the problem before
continuing testing. Error readouts are listed in table 2-4. If the error message does not go away after
corrective action, refer to TM 9-4910-571-12&P.
(e) Confidence
Error Readouts.
COO4
is a typical error readout resulting from the detection of a
faulty VTM during confidence test. For detailed information concerning confidence error readouts, refer to
TM 9-4910-571-1&P.
I
Table
2-2.
Status Readouts.
VTM
Readout
Interpretation
-8.8.8.8
A readout of .8.8.8.8 appears for 1 to 2 seconds each time the power is applied to the VTM.
It means that there is power to the VIM, and that all elements of the readout display are
operative.
_--
-9.9.9.9
A readout of --
indicates the following:
(1) After power turn-on, it signifies that the VTM is ready for testing.
(2)
During a compression unbalance test, it signifies testing is in progress.
A readout of .9.9.9.9 indicates that the VTM is reading a test value beyond the range of its
measurement capability. Either (1) the wrong test number is selected for the parameter
being measured, or (2) there is a fault in the vehicle.
.
PASS
FAIL
A PASS or FAIL readout is the result of a test that checks the condition of a component
being measured. A PASS/FAIL readout means just that
fails the test.
-
the component either passes or
2-513
Back to Top
