TM-9-2320-387-24-1

TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE, VOLUME 1

DECEMBER 1997

CHANGE 1

TM-9-2320-387-24-1 - Page 874 of 1205

I

TM

9-2320-387-24-l

1 4-80.

WIRING HARNESS CONNECTOR REPAIR (Cont’d)

I

e. Receptacle Assembly Repair

NOTE

Refer to TB SIG-222 for soldering instructions.

1.

Strip cable insulation (1) to depth of solder wells (5) on inserts (61.

2.

Slide cable ends (3) through grommet retaining nut (2) and grommet (41.

3.

Place cable ends (31 into solder wells (5) and solder.

4.

Slide grommet (4) over inserts (5) and press into receptacle (71 until seated.

5.

Screw grommet retaining nut (2) into receptacle (7) until seated.

P

7

m

m

m

m

IProtective

Control Box Lower Cannon Plug Assembly Repair

1

1.

Strip cable insulation (8) to depth of solder wells (16) on inserts (14).

2.

Slide cable ends (101 through grommet retaining nut (91 and grommet (11).

3.

Slide insulation sleeving (17) over lead 67A (181.

4.

Place cable ends (10) into solder wells (16) and solder.

NOTE

Ensure insulation sleeving passes through grommet to provide a

water-tight fit.

5.

Slide insulation sleeving (171 up to solder well end (151, and heat-shrink insulation sleeving (171.

6.

Slide grommet (11) over inserts (14) and press into shell assembly (12) and coupling nut (131 until

seated.

7.

Install grommet retaining nut (9) into shell assembly (12) until seated.

FOLLOW-ON TASK: Connect battery ground cables (para. 4-681.

4-148