TM-9-2320-387-24-1
TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113
TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE, VOLUME 1
DECEMBER 1997
CHANGE 1
TM-9-2320-387-24-1 - Page 876 of 1205
TM 9-2320-387-24-l
I
5-2. TRANSMISSION SERVICE
This task covers:
a.
Draining
Fluid
b.
Transmission
Filter Removal
c.
Transmission
Filter Installation
d.
Replenishing
Fluid
INITIAL SETUP:
Tools
General
mechanic’s
tool kit:
automotive
(Appendix
B, Item 1)
Maintenance
and repair
shop equipment:
automotive
(Appendix
B, Item 2)
RIateriaWParts
Filter assembly
(Appendix
G, Item 51)
Transmission
oil pan gasket
(Appendix
G, Item 64)
TWO locknuts
(Appendix
G, Item 157)
Transmission
fluid (Appendix
C, Item 37)
Drycleaning
solvent (Appendix
C, Item 26)
nlanual
References
TM 9-2320-387-10
TM 9-2320-387-24P
General Safety Instructions
Drycleaning
solvent is flammable
and will not be
used near an open flame.
nlaintenonce
Level
Unit
.
a. Draining Fluid
NOTE
l
Do not shift through
driving gear ranges
when warming
trans-
mission fluid for removal.
Shifting
through
driving gear ranges
is a procedure
used only when refilling
transmission
fluid.
l
Transmission
should be warm when draining
fluid.
l
Have drainage
container
ready to catch fluid.
1.
Remove drainplug
(1) and gasket (2) from oil pan (3). Allow fluid to drain.
NOTE
Inspect fluid for grit, foaminess,
and/or milkiness.
If present, refer to
DS maintenance
(chapter
14).
2.
Install gasket
(2) and drainplug
(1) in oil pan (3) and tighten
drainplug
(1) to 20 lb-ft (27 N-m).
5-2
Back to Top
