TM-9-2320-387-24-2
TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113
TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE, VOLUME 2
DECEMBER 1997
CHANGE 1
TM-9-2320-387-24-2 - Page 271 of 1555
11-36.1. LEFT FRONT UNDERBODY ARMOR INSTALLATION (Cont’d)
TM 9-2320-387-24-2
Change 1
11-68.7
10.
Remove four capscrews (20) and washers (21) securing left front underbody armor (6) to resilient
mount shim (8).
11.
Remove six capscrews (19) from left front underbody armor (6) and left front underbody angle (9).
12.
Remove six socket-head screws (10) and three retainer plates (11).
13.
Remove two capscrews (17), washers (16), and spacers (15), from inner and outer holes in left front
underbody armor (6) and left rear underbody (13).
14.
Remove three capscrews (2) and locknuts (4) from left front underbody armor (6) and driver’s side
footwell outer armor (5).
15.
Remove two socket-head screws (14) from front and rear holes in left front underbody armor (6) and
vehicle side panel (18).
16.
Using hydraulic jack, slowly lower left front underbody armor (6) and remove from underneath
vehicle.
17.
Enlarge fifteen holes in left front underbody armor hat section (7) to 17/32 in. (13.5 mm).
18.
Install fifteen AVK fasteners (12) into left front underbody hat section (7).
4
5
2
~
8
20
21
19
2
14
18
17
16
15
14
13
6
12
11
10
7
9
~
Back to Top
