TM-9-2320-428-10
TRUCK, CARGO, 8X8, M977
TECHNICAL MANUAL; OPERATOR'S MANUAL
JUNE 2009
TM-9-2320-428-10 - Page 268 of 1072
SETUP OUTRIGGERS - Continued
Figure 9.
8.
Install two retaining pins (6).
9.
Move right-hand outrigger jack (RH O/R JACK) control lever (10) to DOWN position
and lower outrigger cylinder (8) until rod end is seated in outrigger pad (4).
10.
Install two retaining pins (6).
JACK OUTRIGGERS
WARNING
•
Do not raise vehicle tires off ground with outrigger jack cylinders.
Vehicle could roll over. Always chock front wheels when using
outriggers. Failure to comply may result in injury or death to
personnel.
•
Crane must be level from side to side. Use of crane in unlevel position
can cause vehicle to turn. Failure to comply may result in injury or
death to personnel.
NOTE
•
Operate left and right outrigger jack (LH O/R JACK and RH O/R
JACK) control levers at same time.
TM 9-2320-428-10
0042
0042-10
Back to Top
