TM-9-2320-434-10

TRUCK, LOAD HANDLING SYSTEM (LHS), 8X8, M1120

TECHNICAL MANUAL; OPERATOR'S MANUAL

JUNE 2009

TM-9-2320-434-10 - Page 604 of 1324

OPERATION - Continued

WARNING

Never drive with LHS NO TRANSIT indicator illuminated. An illuminated

indicator means LHS is not fully stowed. Failure to comply may result in

injury or death to personnel.

NOTE

LHS OVER LOAD indicator will illuminate when main frame cylinders are

fully retracted and joystick is being activated.

18.

Hold joystick (8) to LOAD position until hook arm cylinders (9) are fully retracted.

CAUTION

•

Engine speed must be at idle before using hydraulic selector switch,

or damage to equipment may result.

•

Hydraulic selector switch must remain in MAN TRANS while vehicle

is traveling or damage to equipment may result.

19.

Turn hydraulic selector switch (7) to MAN TRANS.

20.

Set PTO ENGAGE switch (5) to OFF position. Indicator light (6) will go out.

NOTE

If load locks do not engage, raise flatrack slightly and lower again.

Flatrack should seat completely and engage load locks.

21.

Inspect that load locks (16) are engaged and flatrack is fully loaded on vehicle.

TM 9-2320-434-10

0069

0069-8