TM-9-2330-227-14-P
SEMITRAILER, VAN: SHOP, 6-TON, SINGLE AXLE, M146
TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
JUNE 1985
TM-9-2330-227-14-P - Page 317 of 576
TM 9-2330-227-14&P
BRAKESHOE ASSEMBLY REPAIR, ONE-CYLINDER BRAKE ASSEMBLY OPTION - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REPAIR - CONTINUED
1.
Brake lining (1)
16 rivets (3)
Using brake reliner, remove.
and brakeshoe (2)
2.
Brakeshoe (2)
Brake lining (1)
Take off.
3.
Bushing (4)
a.
b.
c.
d.
a.
b.
4.
Brakeshoe (2)
5.
Brakeshoe (2)
New bushing (4)
Place brakeshoe (2) in bed of arbor
press.
Using 3-inch brass drift placed be-
tween bushing (4) and ram of press,
drive out.
Get rid of bushing (4).
Using wire brush and drycleaning
solvent, clean brakeshoe (2).
Check for cracks, breaks in welds,
distortion, warping, and oversize
rivet holes (5).
If defective, replace (page 4-88).
Using arbor press, start bushing (4) in
anchor pin hole of brakeshoe (2), and
drive in until flush with face of brake-
shoe (2).
NOT E
If drums have been turned, a shim must be used between brakeshoe and lining. Shim
must be the same thickness as the total depth of cut made when turning the drum.
TA231356
5-43
Back to Top
