TM-9-2330-227-14-P

SEMITRAILER, VAN: SHOP, 6-TON, SINGLE AXLE, M146

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

JUNE 1985

TM-9-2330-227-14-P - Page 315 of 576

TM 9-2330-227-14&P

BRAKESHOE ASSEMBLY REPAIR, TWO-CYLINDER BRAKE ASSEMBLY - CONTINUED

ACTION

LOCATION

ITEM

REMARKS

REPAIR - CONTINUED

1.

Brake lining(1)

16 rivets (3)

Using brake reliner, remove.

and brakeshoe (2)

2.

Brakeshoe (2)

Brake lining (1)

a. Take off.

b. Using wire brush and drycleaning

solvent, clean brakeshoe (2).

3.

Brakeshoe (2)

a. Check for cracks, breaks in welds,

distortion, warping, and oversize

rivet holes (4).

b. If defective, replace (page 4-84).

NOT E

If drums have been turned, a shim must be used between brakeshoe and lining. Shim

must be the same thickness as the total depth of cut made when turning the drum.

4.

Brakeshoe (2)

New brake lining

a.

(1), shim (5),

b.

and 16 rivets (3)

c.

Line up holes.

Using brake reliner, put in rivets

(3), starting in center and working

outward.

Using 0.002-inch (0.051-mm) thick-

ness gage, check fit.

Gage should not penetrate past

rivets.

5-41