TM-9-2330-227-14-P
SEMITRAILER, VAN: SHOP, 6-TON, SINGLE AXLE, M146
TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
JUNE 1985
TM-9-2330-227-14-P - Page 366 of 576
5-92
TM 9-2330-227-14&P
DECK - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REPAIR - CONTINUED
1.
Molding (1) at
Screws (2)
Using number two cross-tip screwdriver,
wall nearest board
unscrew and take out.
to be replaced
2.
Sidewall
Molding (1)
Take off.
NOT E
Molding will have to be removed from front wall when replacing a short board. Molding
on either side of rear doors will be removed when replacing a long board.
Remove threshold plates or striker plates only as required to replace a damaged board.
Molding (3)
Rear wall
Threshold
plate (5)
Deck at
rear door s
Striker
plates (8)
Deck at
rear doors
Threshold
plate (11)
Deck at
side door
Striker
plate (14)
Screws (4)
Molding (3)
Four screws (6)
and nuts (7)
Threshold
plate (5)
Four screws (9)
and four
screws (10)
Striker
plates (8)
Three screws (12)
and nuts (13)
Threshold
plate(11)
Two screws (15)
and two
screws (16)
Using number two cross-tip screwdriver,
unscrew and take out.
Take off.
Using 3/16-inch flat-tip screwdriver,
1/2-inch socket, and ratchet handle with
1/2-inch drive, unscrew and take out.
Using pry bar, take off.
a. Using 3/16-inch flat-tip screwdriver,
unscrew screws (9) and take out.
b. Using number two cross-tip screw-
driver, unscrew screws (10) and
take out.
Note location of two screw types.
Using pry bar, pry out.
Note positioning of plates.
Using 3/16-inch flat-tip screwdriver,
1/2-inch socket, and ratchet handle with
1/2-inch drive, unscrew and take out.
Using pry bar, pry off.
a. Using 3/16-inch flat-tip screwdriver,
unscrew screws (15) and take out.
Back to Top
