TM-9-2330-227-14-P

SEMITRAILER, VAN: SHOP, 6-TON, SINGLE AXLE, M146

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

JUNE 1985

TM-9-2330-227-14-P - Page 358 of 576

5-84

TM 9-2330-227-14&P

LEFT REAR DOOR

This task covers:

Repair (page 4-84)

INITIAL SETUP

Tools

Materials/Parts

Brush, wire

Adhesive (item 1, appendix E)

Hammer, ball-been, machinist’s, l-lb

Rivets, blind (as required)

Handie, ratchet, l/2-inch drive

Piiers, siipjoint, straight-nose

Personnei Required

Punch, drive-pin, l/16-inch

Punch, drive-pin, l/8-inch

One

Punch, drive-pin, 3/16-inch

Screwdriver, cross-tip, number two

Equipment Condition

Screwdriver, fiat-tip, 3/8-inch

Socket, l/2-inch drive, l/2-inch

Ladder removed (page 4-183).

Wrench, open-end, l/2-inch

Left rear door removed (page 4-166).

ACTION

LOCATION

ITEM

REMARKS

NOTE

Disregard any difference in the number of panel rivets used on your door as compared to

the number shown in this procedure. This may vary.

Four inner

16 screws (2)

Using number two cross-tip screwdriver,

frame strips (1)

take off.

26 rivets (3)

a. Using l/8-inch drive-pin punch and

bail-peen hammer, drive punch through

center of rivet head with a solid biow

of hammer.

Rivet heads will either fall off or

can be lifted off with screwdriver.

b. Using 3/16-inch drive-pin punch and

ball-peen hammer, drive out remaining

part of rivet (3).

3. Door(4)

Four inner

Lift off.

frame strips (1)

Four screws (6)

Using number two cross-tip screwdriver,

unscrew and take out.