TM-9-2330-238-14

CHASSIS, SEMITRAILER: 6-TON, 4-WHEEL M295A1; SEMITRAILER, VAN: EXPANSIBLE, 6-TON, 4-WHEEL M313; SEMITRAILER, VAN: SHOP, FOLDING SIDES, 6-TON, 4-WHEEL M447 AND M447C; SEMITRAILER, VAN: REPAIR PARTS, SHOP EQUIPMENT, 6-TON, 4-WHEEL M749; SEMITRAILER, VAN: REPAIR PARTS STORAGE, 6-TON, 4-WHEEL M750

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL

JULY 1992

  TM-9-2330-238-14 - Page 268 of 462

TM 9-2330-238-14
4-71. FUEL TANK REPLACEMENT (Con’t).
7.
Position filler neck tube (28) and filler neck opening cap (29) in rubber hose (6) and secure with outer clamp (5).
8.
Carefully position fuel tank (15) and shield assembly (23) in place on chassis and secure with four screws (1 9),
washers (20), new Iockwashers (21), and nuts (22).
9.
Position block (2) on chassis and install two screws (1).
10.
Position clamp (27) on filler neck (28) and chassis and secure with two screws (7), new Iockwashers (4), and
nuts (3).
c.
REMOVAL (M749 SOUTHWEST MODEL VRP, SERIAL NUMBERS V001 THROUGH V356)
1.
Remove filler opening cap (39) and filler neck (38) from fuel tank (37).
2.
Remove four screws (36), Iockwashers (35), nuts (34), front support (32), rear support (40), and fuel tank (37)
from chassis. Carefully lower front support, rear support, and fuel tank to ground. Discard Iockwashers.
3.
Remove four screws (41), fuel gage (30), and gasket (31) from fuel tank (37). Discard gasket.
4.
Remove fuel tank drain plug (33) from fuel tank (37).
TA702043
4-170


Back to Top