TM-9-2330-238-14

CHASSIS, SEMITRAILER: 6-TON, 4-WHEEL M295A1; SEMITRAILER, VAN: EXPANSIBLE, 6-TON, 4-WHEEL M313; SEMITRAILER, VAN: SHOP, FOLDING SIDES, 6-TON, 4-WHEEL M447 AND M447C; SEMITRAILER, VAN: REPAIR PARTS, SHOP EQUIPMENT, 6-TON, 4-WHEEL M749; SEMITRAILER, VAN: REPAIR PARTS STORAGE, 6-TON, 4-WHEEL M750

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL

JULY 1992

TM-9-2330-238-14 - Page 298 of 462

TM 9-2330-238-14

4-82. HOOK STRIP REPLACEMENT (Con't).

INSTALLATION

WARNING

b.

Dry cleaning solvent P-D-680 is toxic and flammable. Always wear protective goggles

or glasses and wear gloves. Use in a well ventilated area. Avoid contact with skin,

eyes, and clothes, and do not breath vapors. Do not use near open flames or excessive

heat. The solvents flash point Is 100

o

F-138°F (38°C-59°C). If you become dizzy while

using cleaning solvent immediately get fresh air and medical help. If solvent contacts

eyes, immediately flush your eyes and get medical aid. Failure to follow this warning

may result In injury or death to personnel.

NOTE

Make sure end-plate or corner post mounting surfaces are clean. Hook strips

are adhesive backed, and clean mounting surfaces are necessary for proper

bonding.

1.

Clean all mounting surfaces with dry cleaning solvent.

NOTE

Use existing rivet holes as a placement guide for installing new hook strip.

2.

Aline new 1-inch (2.54 cm,) hook strip (5) 1/16

(1.59mm) to 1/8-inch (3.17mm) down from from

top edge of lower door (4). Note position of rivet

holes before covering with hook strip (5).

4-200

Change 1