TM-9-2330-247-14-P

CHASSIS, TRAILER: GENERAL PURPOSE, 3-1/2 TON, 2-WHEEL, M353

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS)

MARCH 1992

TM-9-2330-247-14-P - Page 106 of 320

TM 9-2330-247-14&P

4-30. HANDBRAKE CABLE AND LEVER ASSEMBLY (Con’t)

ACTION

LOCATION

ITEM

REMARKS

23.

Backing plate

Cable assembly

Pull toward front to remove slack.

(35)

(1)

End of cable assembly conduit should

touch backing plate (35).

24.

Backing plate

Bracket (32)

Place into position.

studs (31)

Ensure that bracket (32) fits in groove on

cable assembly (1).

25.

Two Iockwashers

Screw on and tighten using ~e in. socket and ratchet

(33) and nuts (34)

handle with ½ in. drive.

Ensure that bracket (32) lip fits in notch on

cable assembly conduit.

26.

Axle offset

beam (23)

27.

Clamp (24) and

axle offset

beam (23)

28.

Frame (16)

29.

Cable bracket

(18) and

frame (16)

Clamp (24) and

a. Line up cable assembly (1) with screw hole.

cable assembly (1)

b. Put clamp (24) on cable assembly (1) across

from hole.

Leave enough slack so cable assembly (1)

can move as offset beam (23) moves.

Screw (25)

Cable assembly

(1) and cable

bracket (18)

Two screws (17),

Iockwashers (15),

and nuts (14)

Screw in and tighten using no. 2 cross-tip screw-

driver.

a. Lineup cable assembly (1) so conduit end (19) is

between holes.

b. Put cable bracket (18) into position.

Screw in and tighten using ½ in. socket, ratchet

handle with ½ in. drive, and ½ in. box-end wrench.

4-52