TM-9-2330-324-14-P

TRAILER, CARGO: 1-1/2-TON, 2-WHEEL, M105A3

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

JULY 2002

TM-9-2330-324-14-P - Page 162 of 350

TM 9-2330-324-14&P

0033 00-4

SERVICE BRAKE ASSEMBLY MAINTENANCE—Continued

0033 00

ASSEMBLY

NOTE

If replacing brakeshoes (8 and 17) only, perform steps 4 through 9.

1.

Install pins (6, 18, 23, and 29) on brakeshoes (8 and 17) with four new lockwashers (9) and nuts

(10).

2.

Install slack adjusting wheel (27) and brake adjusting screw (28) on each support (12).

3.

Position backing plate (11), two supports (12), and cable ramp (25) on axle (13) and install 12 bolts

(26), new lockwashers (16), and nuts (15).

4.

Position brakeshoe (17) on backing plate (11) and install bolt (14), sleeve (22), flatwasher (21), new

lockwasher (19), and nut (20).

5.

Position brakeshoe (8) on backing plate (11) and install sleeve (33), flatwasher (32), new lockwasher

(31), and screw (30).

6.

Install link (7) on pin (23). Install brake lever (5) on pin (6). Pin on brake lever must engage slot in link.

7.

Install two spring washers (4), flatwashers (3), and slotted washers (2) on pins (6 and 23).

8.

Install two springs (1) on pins (6, 18, 23, and 29).

9.

Connect handbrake cable (24) to brake lever (5).

7

6

8

9

10

30

31

32

33

29

1

28

27

26

25

12

12

11

13

14

15

16

24

20

19

18

17

22

21

23

1

4

2

3

5