TM-9-2330-324-14-P

TRAILER, CARGO: 1-1/2-TON, 2-WHEEL, M105A3

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

JULY 2002

TM-9-2330-324-14-P - Page 163 of 350

TM 9-2330-324-14&P

0033 00-5

SERVICE BRAKE ASSEMBLY MAINTENANCE—Continued

0033 00

ASSEMBLY—Continued

10.

If disconnected, connect axle hydraulic lines to backing plate (WP 0037 00).

11.

Install hub and brakedrum (WP 0039 00).

ADJUSTMENT

NOTE

•

To ensure an accurate adjustment, this procedure must be performed

when brakeshoes are cool.

•

Perform this adjustment at each wheel to adjust brakes.

1.

Raise one side of trailer with rear jack and place a jackstand on corner of rear crossmember. Lower

and remove rear jack. Repeat for other side.

2.

On passenger (right) side of trailer, turn upper brakeshoe adjusting bolt (36) and lower brakeshoe

adjusting bolt (37) clockwise until brakes are completely released. Check to see that wheel turns

freely.

3.

On driver (left) side of trailer, turn upper brakeshoe adjusting bolt (36) and lower brakeshoe

adjusting bolt (37) counterclockwise until brakes are completely released. Check to see that wheel

turns freely.

36

37

NOTE

Overtightened

bearing is evident if a drag occurs when brakes are

completely backed off.