TM-9-2330-326-14-P

SEMITRAILER, TACTICAL, DROP DECK BREAKBULK/CONTAINER TRANSPORTER, 22-1/2 TON, M871A3

TECHNICAL MANUAL; OPERATOR’S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

FEBRUARY 2006

TM-9-2330-326-14-P - Page 141 of 540

TM 9-2330-326-14&P

6-65

6-23. LANDING GEAR REPLACEMENT.

This Task Covers:

a. Removal

b. Installation

c. Follow-On Tasks

Initial Setup:

Tools and Special Tools:

Materials:

Tool kit, general mechanic’s (Item 4, Appendix B-3)

Oil, lubricating (Item 9, Appendix F)

Equipment Conditions:

References:

Semitrailer disconnected from prime mover

Appendix C

Semitrailer blocked on jack stands

Appendix H-18

Tires chocked

NOTE

For detailed procedures and/or instructions see reference “H” Section.

General Procedure:

a. Removal.

1.

Remove two bolts (2) and self-locking nuts (6) from cross drive shaft (3). Discard self-locking

nuts.

2.

Remove 10 bolts (20) and locknuts (19) from landing leg upper bracket. Discard locknuts.

3.

Remove two bolts (8) and locknuts (19) from landing leg lower bracket and remove landing leg

(1) from semitrailer. Discard locknuts.

4,

Remove hex screw (18), self-locking nut (6), and pull pin (9) from landing gear shoe assembly.

Discard self-locking nut.

5.

Remove two hitch pins (17), washers (16), ties (11), pins (12), front shoe assembly (10), and

rear shoe assembly (15) from landing leg.

6.

Remove two pop rivets (14) and lanyards (13) from landing leg (1). Discard pop rivets (if

required).

7.

Repeat steps 1–6 for remaining landing leg.

8.

Remove bolt (4), two washers (5), and self-locking nut (6) from landing leg crank (7) and remove

crank (7). Discard self-locking nut.