TM-9-2330-326-14-P
SEMITRAILER, TACTICAL, DROP DECK BREAKBULK/CONTAINER TRANSPORTER, 22-1/2 TON, M871A3
TECHNICAL MANUAL; OPERATOR’S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
FEBRUARY 2006
TM-9-2330-326-14-P - Page 85 of 540
TM 9-2330-326-14&P
6-9
6-3. CLEARANCE LIGHTS REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
c. Follow-On Tasks
Initial Setup:
Tools and Special Tools:
Materials:
Tool kit, general mechanic’s (Item 4, Appendix B-3)
Compound, antiseize (Item 4, Appendix F)
Dielectric grease (Item 34, Appendix F)
Equipment Conditions:
Landing legs down
References:
Semitrailer disconnected from prime mover
Appendix H-16
Tires chocked
Ground boards emplaced
Electrical schematic, Section 6, Page 6-6
WARNING
Disconnect all electrical power before performing any maintenance on
the electrical system. Failure to do so could result in injury to personnel.
NOTE
•
There are nine clearance lights on the M871A3 semitrailer.
The two front clearance lights (2) are held in place with three
self-tapping screws. The seven remaining side and rear
clearance lights (1) use two self-tapping screws each. This
procedure removes and installs one front clearance light; the
remaining clearance lights are removed and installed the
same way.
•
For detailed procedures and/or information see reference
“H” Section.
General Procedure:
a. Removal.
1.
Disconnect wiring harness from clearance light connector behind bulkhead.
2.
Remove three self-tapping screws (3) and clearance light (1 or 2). Discard screws.
Back to Top
