TM-9-2330-326-14-P
SEMITRAILER, TACTICAL, DROP DECK BREAKBULK/CONTAINER TRANSPORTER, 22-1/2 TON, M871A3
TECHNICAL MANUAL; OPERATOR’S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
FEBRUARY 2006
TM-9-2330-326-14-P - Page 87 of 540
TM 9-2330-326-14&P
6-11
6-4. LED TAILLIGHTS REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
c. Follow-On Tasks
Initial Setup:
Tools and Special Tools:
Materials:
Tool kit, general mechanic’s (Item 4, Appendix B-3)
Dielectric grease (Item 34, Appendix F)
Compound, Antiseize (Item 4, Appendix F)
Equipment Condition
References:
Landing legs down
Appendix H-16
Semitrailer disconnected from prime mover
Electrical Schematic, Section 6, Page 6-6
Tires chocked
Ground boards emplaced
WARNING
Disconnect all electrical power before performing any maintenance
on the electrical system. Failure to do so could result in injury.
NOTE
•
There are four taillights and they are removed and installed the
same way. This procedure covers one taillight.
•
For detailed procedures and/or information see referenced
“H” Section.
General Procedure:
a. Removal.
1. Disconnect taillight connector from wiring harness connector behind bulkhead.
2. Disconnect ground wire from taillight behind bulkhead.
NOTE
Only the two outer taillights have ground wires.
3. Remove three self-tapping screws (2) and taillight (1). Discard screws.
Back to Top
