TM 9-2330-330-14&P
0026 00-1
ALTERNATOR AND CHARGING CIRCUIT TROUBLESHOOTING
0026 00
THIS WP COVERS:
Alternator and Charging Circuit Troubleshooting
INITIAL SETUP:
Maintenance Level
Tools and Special Tools
Organizational
Tool kit, general mechanic’s (item 4, WP 0171 00)
Multimeter (item 2, WP 0171 00)
References
TM 9-6140-200-14
WP 0056 00
WP 0116 00
WP 0117 00
To troubleshoot M969A3 alternator and charging circuit, perform the test/inspections and corrective
actions provided in Table 1.
Table 1. Troubleshooting Procedures.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1.
UNDERCHARGED
BATTERIES
1.
Check for loose or
corroded battery terminals,
cables, and connections,
and moisture and dirt on
top of batteries.
2.
Look for worn or glazed
pulley or loose belt on
alternator.
Clean battery and clean and
tighten battery connections (refer
to WP 0056 00). Replace any
damaged cables (refer to WP
0056 00). Charge and test
batteries (refer to TM 9-6140-
200-14). Verify problem is
solved. If battery still does not
hold a charge, go to step 2.
Adjust alternator drive belt (refer
to WP 0116 00) if loose. Replace
alternator belt (refer to WP 0117
00) if glazed, cracked or worn. If
pulley is worn or glazed, notify
Direct Support maintenance.