TM-9-2330-335-14-P

SEMITRAILER, TACTICAL, BREAKBULK/CONTAINER TRANSPORTER, 22-1/2 TON, RESET M871R, M871A1R AND M871A2R

TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE MANUAL (INCLUDES REPAIR PARTS AND SPECIAL TOOLS LIST)

SEPTEMBER 2008
TM-9-2330-335-14-P

  TM-9-2330-335-14-P - Page 325 of 640

0069-3
TM 9-2330-335-14&P
0069
CLEANING INSTRUCTIONS - CONTINUED
WARNING
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle
pressure when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when
cleaning components. DO NOT direct compressed air against human skin. To prevent injury, user
must wear protective goggles or face shield. Make sure air stream is directed away from used for
clearing restrictions should never exceed 30 psi (207 kPa). Wear protective clothing (goggles/
shield, gloves, etc.) and use caution to avoid injury to personnel.
3.
Clear all threaded holes with compressed air to remove dirt and cleaning fluids.
Grease Seals, Electrical Cables, and Flexible Hoses
00069
CAUTION
Do not wash grease seals, electrical harnesses, and flexible hoses with solvent cleaning compound
or mineral spirits. Serious damage or destruction of material would result.
Wash electrical cables and flexible hoses with a solution of detergent and water and wipe dry.
Bearings
00069
Clean bearings in accordance with TM 9-214.
END OF TASK
INSPECTION INSTRUCTIONS
00069
NOTE
All damaged areas should be marked for repair or replacement.
1.
All components and parts must be carefully checked to determine if they are serviceable for use, can be repaired,
or must be scrapped.
2.
Inspect drilled and tapped (threaded) holes for the following:
a.
Wear, distortion, cracks, and any other damage in or around holes.
b.
Threaded areas for wear, distortion (stretching), and evidence of cross-threading.
3.
Inspect metal lines, flexible lines (hoses), and metal fittings for the following:
a.
Metal lines for sharp kinks, cracks, bad bends, and dents.
b.
Flexible lines for fraying, evidence of leakage, and loose metal fittings or connectors.
c.
Metal fittings and connectors for thread damage and worn or rounded hex heads.
4.
Inspect castings, forgings, and machined metal parts for the following:
a.
Machined surfaces for nicks, burrs, raised metal, wear, and other damage.
b.
Inner and outer surfaces for breaks and cracks.
5.
Inspect bearings in accordance with TM 9-214.
END OF TASK


Back to Top