TM-9-2330-342-23-P
PALLETIZED LOAD SYSTEM TRAILER (PLST) M1076 A1
TECHNICAL MANUAL; FIELD MANUAL
OCTOBER 2012
TM-9-2330-342-23-P - Page 1033 of 1348
FIELD MAINTENANCE
GENERAL INSTALLATION INSTRUCTIONS
INITIAL SETUP:
Not Applicable
PREPARATION
When unpacking items, remove all packing material, barrier paper, tape, plastic bags, protective caps, and protective
grease coatings. Handle and store removed components carefully.
END OF TASK
SEALING COMPOUNDS
CAUTION
Use sealing compound sparingly and only on male threads. Do not apply compound on first
two threads to avoid contamination of system from compound. Do not apply compound to
hose connections or fittings with preformed packing. Damage to equipment may result.
Use sealing compounds as required in each maintenance task.
END OF TASK
TORQUING
Tighten bolts, screws, washers, hoses and fittings as required in Torque Limits (WP
0134) or in each maintenance
task.
END OF TASK
IDENTIFICATION TAGS
Put hoses, tubes, lines, and electrical wiring in place by matching identification tags and markings on equipment.
END OF TASK
HOSES, AIR LINES, AND WIRING
After installing hoses, air lines, and wiring, ensure that they do not contact moving parts or components edges.
Secure in place, out of way with cable ties and cushion clips.
END OF TASK
HOSES AND FITTINGS TIGHTENING PROCEDURE
1.
Install hose nut (Figure 1, Item 2) on fitting (Figure 1, Item 1).
TM 9-2330-342-23&P
0130
0130-1
Back to Top
