TM-9-2330-342-23-P
PALLETIZED LOAD SYSTEM TRAILER (PLST) M1076 A1
TECHNICAL MANUAL; FIELD MANUAL
OCTOBER 2012
TM-9-2330-342-23-P - Page 1039 of 1348
FIELD MAINTENANCE
GENERAL REMOVAL INSTRUCTIONS
INITIAL SETUP:
Not Applicable
WORK REQUIRED
Remove parts if repair or replacement is required. Do not disassemble a component any further than needed.
END OF TASK
PREPARATION
Before removal of any electrical or air system components, ensure system component is not energized or
pressurized. Disconnect intervehicular cable. Relieve air system pressure. Before removal of fasteners (nuts,
locknuts), remove any paint on threads to prevent binding of fastener.
END OF TASK
IDENTIFICATION
To ease assembly and installation, tag and mark shims, connectors, wires, and mating ends of lines before
disconnecting them. Identify similar parts to ensure correct assembly.
END OF TASK
POSITION OF VALVES
Before removing valve handles, mark or diagram their positions when open and closed. This will help during
assembly.
END OF TASK
TIRE REMOVAL
Before removing any tires, position jackstand(s) under axle(s) as shown in wheel/tire replacement (WP
0094).
END OF TASK
LOCATION
Before removing cable ties, cushion clamps, hoses, tubing, wiring, etc., note the location, position, and routing to
ensure correct assembly.
END OF TASK
END OF WORK PACKAGE
TM 9-2330-342-23&P
0131
0131-1/2 blank
Back to Top
