TM-9-2330-342-23-P

PALLETIZED LOAD SYSTEM TRAILER (PLST) M1076 A1

TECHNICAL MANUAL; FIELD MANUAL

OCTOBER 2012

TM-9-2330-342-23-P - Page 281 of 1348

LED

COMPOSITE

LIGHT

LED COMPOSITE

LIGHT WIRES

WIRE

HARNESS

WIRES

WIRE 1435

Figure 2.

LED Composite Light and Wire 1435.

2.

Connect button probe cable red lead to wire 1435.

3.

Connect button probe cable black lead to a known good ground.

4.

Perform ICE Test 91.

5.

Meter should display a reading of less than 200 ohms.

CONDITION/INDICATION

Is continuity measured between wire 1435 at LED composite light and a known good ground?

DECISION

Yes - Go to (Step 4 - Are 22 to 28 vdc measured on wire 1008B/21 at LED composite light?).

No - Go to (Step 3 - Can rear side marker light harness wire 1435 be repaired?).

STEP 3

Can rear side marker light harness wire 1435 be repaired?

WARNING

Remove all jewelry such as rings, ID tags, bracelets, etc. prior to working on or around vehicle.

Jewelry and tools can catch on equipment, contact positive electrical circuits, and cause a

direct short, severe burns, or electrical shock. Failure to comply may result in injury or death

to personnel.

NOTE

Wire is not repairable if damage cannot be visually located or if a prior repair has already

reduced length of wire. Wire is not repairable if after repair, wire is too short to reach its

connection point.

1.

Visually check if rear side marker light harness wire 1435 can be repaired.

TM 9-2330-342-23&P

0025

0025-3