TM-9-2330-342-23-P

PALLETIZED LOAD SYSTEM TRAILER (PLST) M1076 A1

TECHNICAL MANUAL; FIELD MANUAL

OCTOBER 2012

TM-9-2330-342-23-P - Page 284 of 1348

9.

Perform ICE Test 89.

10.

Meter should display a reading between 22 and 28 vdc.

CONDITION/INDICATION

Are 22 to 28 vdc measured on wire 1008B at rear junction box?

DECISION

Voltage OK - Go to (Step 6 - Can composite light harness wire 1008B be repaired?).

Voltage Faulty - Go to (Step 7 - Does test equipment pass offset test?).

STEP 6

Can composite light harness wire 1008B be repaired?

WARNING

Remove all jewelry such as rings, ID tags, bracelets, etc. prior to working on or around vehicle.

Jewelry and tools can catch on equipment, contact positive electrical circuits, and cause a

direct short, severe burns, or electrical shock. Failure to comply may result in injury or death

to personnel.

NOTE

Wire is not repairable if damage cannot be visually located or if a prior repair has already

reduced length of wire. Wire is not repairable if after repair, wire is too short to reach its

connection point.

1.

Have assistant turn OFF lights. Refer to vehicle Operator's manual (WP

0190).

2.

Have assistant turn engine start switch to OFF. Refer to vehicle Operator's manual (WP

0190).

LED

COMPOSITE

LIGHT

LED COMPOSITE

LIGHT WIRES

WIRE

HARNESS

WIRES

WIRE

1008B

WIRE

21

Figure 6.

LED Composite Light and Wire 1008B/21.

3.

Visually check if composite light harness wire 1008B can be repaired.

TM 9-2330-342-23&P

0025

0025-6