TM-9-2330-342-23-P
PALLETIZED LOAD SYSTEM TRAILER (PLST) M1076 A1
TECHNICAL MANUAL; FIELD MANUAL
OCTOBER 2012
TM-9-2330-342-23-P - Page 855 of 1348
INSTALLATION
1.
Install mounting bracket (Figure 3, Item 1) in vise.
8
9
1
2
3
4
5
6
7
6
5
Figure 3.
Cart Rear Roller and Spring Installation.
NOTE
Both rear roller assemblies are installed the same way. Left side shown.
2.
Install cotter pin (Figure 3, Item 8) on pin (Figure 3, Item 9).
WARNING
Wear proper eye protection and use care when removing and installing springs. Springs are
under tension and can act as projectiles when released. Failure to comply may result in injury
or death to personnel.
NOTE
Install spring on pin so that longer end of spring extension will align with indent on mounting
bracket and short end is on top of roller bracket bar.
3.
With the aid of an assistant, install pin (Figure 3, Item 9), roller bracket (Figure 3, Item 4), and spring (Figure
3, Item 3) on mounting bracket (Figure 3, Item 1).
4.
Install cotter pin (Figure 3, Item 2) on pin (Figure 3, Item 9).
5.
Install two bushings (Figure 3, Item 6) on roller bracket (Figure 3, Item 4).
TM 9-2330-342-23&P
0100
0100-3
Back to Top
