TM-9-2330-342-23-P
PALLETIZED LOAD SYSTEM TRAILER (PLST) M1076 A1
TECHNICAL MANUAL; FIELD MANUAL
OCTOBER 2012
TM-9-2330-342-23-P - Page 95 of 1348
TEST EQUIPMENT SETUP FOR PRESSURE TEST 49, 50 AND 51 - Continued
4. Connect cable P1 connector to J6 connector on ICE BOX.
CAUTION
If removing PCMCIA card, ensure PCMCIA drive is properly shutdown through Eject
Hardware icon on lower right side of desktop screen toolbar or by shutting down
Soldiers Portable On-system Repair Tool (SPORT). Failure to comply may result in
damage to PCMCIA card.
5. Connect P2 connector to PCMCIA card.
6. Insert PCMCIA card into SPORT PCMCIA slot.
7. Connect P3 end of cable to SPORT power port.
8. Attach cable grounding wire to SPORT ground stud.
9. Connect power cable to J5 ICE BOX connector and to vehicle NATO connector.
10. Connect W1 cable to J1 connector on ICE BOX and to vehicle DCA connector (if available).
11. Place ICE BOX power switch in NATO or DCA setting.
END OF TASK
Maintenance Support Device (MSD) Standard (PCMCIA) ICE Kit Setup
NOTE
TK pressure transducer installation may require adapter.
1. Install TK pressure transducer required:
Table
3.
Transducers.
Test
Transducer
Scale
49
Red stripe
0-25 psi
50
Blue stripe
0-1000 psi
51
Yellow stripe
0-9999 psi
2. Connect W4 cable to installed transducer.
TM 9-2330-342-23&P
0004
0004-3
Back to Top
